
Materials Needed
1x3x6 wood (1 qty)
Plywood (2’x4′ sheet of 3/4″ thick plywood is more than enough)
Cabinet Handle (6-7 inches long)
Wood Glue
Nails for nail gun
Paint or Stain
Small hinge
Tools Needed
Nail Gun
Sander (hand)
Miter saw (for the kickstand)
Cut List
1×3 : Cut 1 piece at 12 inches long, 1 pieces at 4-1/4″ inches long (angles on each end should be 30″ on one end & 22.5″ on the other)
Plywood: Cut 1 piece at 12 inches X 9-1/4 inches
Instructions
- Mark where holes will go on 1×3’ wood and drill holes so you can attach the hardware.
- Attach your cabinet handle to 1×3’ wood. Then attach the 1×3 piece as shown in video to the plywood using wood glue and nail gun.
- Attach kickstand (4-1/4” piece of wood) to the back using hinge or glue & nails.
- Fill nail holes & paint/stain.
- Done!
*Optional but recommended…add a coat of polyurethane once its done and let fully dry.





Read the Comments +